File content as of revision 1:23b7ed707d25:

//
//  OSHChip_Blinky.cpp
//
//  Default mbed nRF51822 platforms all have BLE added
//
//  Default UART output on OSHChip pin 1 should be connected to OSHChip_CMSIS_DAP connector J5
//  which is the 2 pin connector in the corner of the board. Connect to the pin closest to the
//  corner of the board.  If you are going to use serial input, connect the other pin of J5 to
//  pin 2 of OSHChip. If you are not going to use the UART, OSHChip pins 1 and 2 can be re-assigned
//

#include "mbed.h"
#include "OSHChip_Pin_Names.h"

DigitalOut red_led(PinName LED_RED);
DigitalOut green_led(PinName LED_GREEN);
DigitalOut blue_led(PinName LED_BLUE);

#define DELAY       (100)
#define LED_ON      (0)
#define LED_OFF     (1)

int main(void)
{
    uint32_t    loop_count;
    
    OSHChip_Init();

    loop_count = 0;

    while(1) {
        red_led   = LED_ON;

        wait_ms(DELAY);

        red_led   = LED_OFF;

        wait_ms(DELAY);

        red_led   = LED_ON;
        green_led = LED_ON;

        wait_ms(DELAY);

        red_led   = LED_OFF;
        green_led = LED_OFF;
        blue_led  = LED_ON;

        wait_ms(DELAY);

        blue_led  = LED_OFF;

        printf("Loop Count:  %8d\r\n", loop_count++);
    }
}