ST
A world leader in providing the semiconductor solutions that make a positive contribution to people’s lives, both today and in the future.
You are viewing an older revision! See the latest version
Supported shields
This table summarizes the different shields (non ST X-NUCLEO boards) tested on Nucleo-64, Nucleo-144, B96B and Discovery platforms (only ones having an Arduino Uno connector).
This list is not exhaustive! A shield not present or not mentioned "Tested" does not mean that it will not work!
Shield name | Shield type | Nucleo-64/Nucleo-144/B96B boards status | Discovery F469NI/F769NI/F746NG board status | |
---|---|---|---|---|
mbed Application Shield | Display, Sensors | Tested | Tested | |
Freetronics 16x2 LCD | Display | Tested | ||
Seeed 2.8" TFT Touch V2 | Display | Tested | ||
Seeed SDCard V4b | Storage | Tested (1) | ||
W5200 Ethernet | Connectivity | Tested (1) | ||
Seeed Wifi | Connectivity | Tested (2) | ||
Seeed Bluetooth | Connectivity | Tested (2) | ||
Seeed NFC V2 | Connectivity | Tested (1) | ||
Seeed XBee V2 | Connectivity | Tested (2) | ||
Seeed GPRS V2 | Connectivity | Tested (2) | ||
Ciseco SRF | Connectivity | Tested (2) | ||
Sparkfun GPS | Sensors | Tested (2) | ||
Freescale Multi-Sensor | Sensors | Tested (3) | ||
CN0357-Toxic-gas-measurement | Sensors | Tested | ||
CN0216-Weigh-Scale | Sensors | Tested | ||
Seeed Motor V2 | Drivers | Tested | ||
Seeed Bot | Drivers | Tested | ||
Seeed EL | Drivers | Tested | ||
Seeed Relay V2 | Actuators | Tested | ||
Seeed Energy | Power supply | Tested (4) | ||
Seeed Charger V2 | Power supply | Tested (4) | ||
Seeed Grove V2 | Hook-up | Tested |
Shields support notes
- (1) This shield requires SPI pins remapping because it uses a non-standard 6 pin SPI connector. Please refer to the shield page on mbed for more information.
- (2) To use this shield with Nucleo-64 boards you will need to remove/open SB13 and SB14 and solder/close SB62 and SB63 solder bridges. This will enable the STM32 microcontroller to communicate with the shield using the default serial connection present on D0/D1 pins. As a drawback, the serial communication (used by printf for example) and going via the ST-Link and USB will be disconnected. Alternatively you could use other serial-enabled pins, which have to be connected to the CN3-TX/RX connector. Please refer to the the Nucleo pinout image for serial pins options and to the user manual (USART communication chapter).
- (3) This shield uses I2C on A4/A5 pins and requires bridging of A4<->D14 and A5<->D15.
- (4) This shield requires that the board is configured to boot on external power. On the Nucleo-64, this configuration is done using thez PWR jumper and has to be switched to E5V position.