Digi International Inc. / Mbed 2 deprecated XBeeZB_modem_status

ZigBee Modem Status example for mbed XBeeLib By Digi

Dependencies:   XBeeLib mbed

Description

This example shows how to register a function callback to be aware of modem status changes. This library will call the registered callback whenever the XBee module radio modem changes its status

See Handling modem status changes chapter for more information.

Common Setup

Make sure you have a valid Example Common Setup

Example Setup

This example does not require any additional setup.

Running the example

Build and deploy the example to the mbed module.
Reset the mbed module so the example starts. You should see the example debug information through the debug interface configured in the 'Local Setup' chapter.

It you set up a network as described in the Common Setup section, you should see following modem status in the debug interface:

  • Modem Status 0x0: Corresponds to 'HwReset' meaning 'Hardware reset'
  • Modem Status 0x2: Corresponds to 'JoinedNW' meaning 'Joined network (ZigBee routers and end devices)'

Note: You may not see the HwReset modem status if the device is joining to the coordinator fast (within the call to xbee.init())

If you now unplug the network coordinator you should see following modem status in the debug interface:

  • Modem Status 0x3: Corresponds to 'Disassociated' meaning 'Disassociated (ZigBee)'

config.h

Committer:
spastor
Date:
2015-05-05
Revision:
0:0c8d070617b1
Child:
2:c796a5ac7c69

File content as of revision 0:0c8d070617b1:


#if !defined(__CONFIG_H_)
#define __CONFIG_H_

//#define PATFORM_ARCHPRO

/** Library configuration options */
#define ENABLE_LOGGING
#define ENABLE_ASSERTIONS
#define FRAME_BUFFER_SIZE   4
#define MAX_FRAME_PAYLOAD_LEN  128
#define ENABLE_PM_SUPPORT

#define SYNC_OPS_TIMEOUT_MS       2000

#if defined(PATFORM_ARCHPRO)
#define RADIO_TX            P4_28
#define RADIO_RX            P4_29
#define RADIO_RESET         NC
//#define RADIO_RESET         NC
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            P0_2
#define DEBUG_RX            P0_3
#elif defined(TARGET_LPC1768)
#define RADIO_TX            p9
#define RADIO_RX            p10
#define RADIO_RESET         p30
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            P0_2
#define DEBUG_RX            P0_3
#elif defined(TARGET_FRDM_KL25)
#define RADIO_TX            PTD3
#define RADIO_RX            PTD2
#define RADIO_RESET         NC
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            USBTX
#define DEBUG_RX            USBRX
#elif (defined TARGET_LPC11U24)
#define RADIO_TX            p9
#define RADIO_RX            p10
#define RADIO_RESET         p30
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            USBTX
#define DEBUG_RX            USBRX
#else
#error "Define a platform"
#endif

#endif /* __CONFIG_H_ */