Report
2 months, 1 week ago.

I want to stop serial mode and change to terminal mode [xdot module]

/media/uploads/hcson/xdot-2.jpg /media/uploads/hcson/xdot-1.jpg I want to stop serial mode and change to terminal mode

I changed mtxdot to serial mode so I can not connect to the terminal (tera term) –xdot-na1 module [usb type] [ex] Peer to peer mode change AT+NJM=3 ( P TO P MODE) AT+NA=00112233 (Network Address) AT+NSK=00112233001122330011223300112233 (Network Session Key ) AT+DSK=33221100332211003322110033221100(Data Session Key) AT+TXDR=DR8 (US:DR8-DR13,EU:DR0-DR6) AT+TXF=915500000 (US-ONLY:915.5-919.7) AT&W ATZ AT+SD [reboot] —not connect terminal mode \ view port com10,com11 serial mode=ok

Is there a way to change to factory reset mode?

send +++ (115200bps) not active

Question relating to:

The MultiConnect® xDot™ is a low cost, low power LoRa Module.
Comment on this question
Be the first to answer this question.

To post an answer, please log in.