Important changes to forums and questions
All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.
CAN BUS PROJECT
Topic last updated 12 Nov 2015, by 
dosh dance.
2
replies
dosh dance.
2
replies
JUST STARTED ON A NEW MBED PROJECT UTILIZING THE CAN-BUS. I AM USING MICROCHIP'S MCP2515 CAN BUS MONITOR, SHOWN ABOVE AND FUTERLEC'S CAN BUS NODE TO TEST FUCTIONALITY;
2- 8 BIT ADC CHANNELS.2 DIGITAL O/P AND 3 DIGITAL I/P CHANNELS.
THE MONITOR SHOWS CHANNEL 1 CHANNEL ADC (DATA 9EH) THE USB CONNECTION ON THE CAN BUS NODE IS ONLY USED TO SUPPLY 5 VOLTS. THE OBJECT OF THE EXERCISE IS TO CONNECT FUTERLEC'S CAN NODE TO THE CAN BUS OF THE MBED,AND TO USE MIKROELEKTRONICA'S TFT TO DISPLAY A VIRTUAL ANALOGUE METER. I RECALL THAT A SINE AND COS FUNCTION IS REQUIRED TO PRODUCE A ROTATING VECTOR? (NEEDLE ON A METER) ANY TAKERS AS TO HOW TO DO THIS?
BACK 'T PUB