Important changes to forums and questions
All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.
6 years, 3 months ago.
Nucleo +5V pin only show 2.7V through SWD
I torn apart a Nucleo F446RE into ST-LINK V2 and i's STM32F446RE then connect it again through SWD with this configuration, except without serial TX, RX connected because I use it only for upload firmware.
The probelem is the +5V pin only show 2.7V but +3.3V show 3.29 V.
1 Answer
6 years, 3 months ago.
For STM remote target programming with an Nucleo Board, I did some documentation here: http://www.radioshuttle.de/en/nucleo-st-link-interface-2/ Maybe this helps.