8 years, 9 months ago.

not enough storage

I tried to load the blinky program by drag and drop, but got error not enough storage only 2.5k How do I load programs

Question relating to:

Seeeduino Arch from Seeed Studio is an mbed enabled development board which combines some advantages of mbed and Arduino. Arch is based on NXP LPC11U24 with Arduino form factor and …

1 Answer

8 years, 9 months ago.

On the Seeeduino Arch: Long press reset to enter USB ISP mode, a CRP DISABLD disk will pop up. Delete firmware.bin file and save your program binary file produced by the online compiler instead. Press reset to start new code.

Accepted Answer

Thanks, I was afraid I would remove the bootloader.

posted by James Cullins 22 Jun 2015