Affordable and flexible platform to ease prototyping using a STM32F030R8T6 microcontroller.
Table of Contents
The STM32 Nucleo board provides an affordable and flexible way for users to try out new ideas and build prototypes with any STM32 microcontroller line, choosing from the various combinations of performance, power consumption and features.
The Arduino™ connectivity support and ST Morpho headers make it easy to expand the functionality of the STM32 Nucleo open development platform with a wide choice of specialized shields.
The STM32 Nucleo board does not require any separate probe as it integrates the ST-LINK/V2-1 debugger/programmer.
- STM32F030R8T6 in LQFP64 package
- ARM®32-bit Cortex®-M0 CPU
- 48 MHz max CPU frequency
- VDD from 2.4 V to 3.6 V
- 64 KB Flash
- 8 KB SRAM
- GPIO (55) with external interrupt capability
- 12-bit ADC with 18 channels
- Timers (6)
- I2C (2)
- USART (2)
- SPI (2)
- Two types of extension resources
- Arduino Uno Revision 3 connectivity
- STMicroelectronics Morpho extension pin headers for full access to all STM32 I/Os
- On-board ST-LINK/V2-1 debugger/programmer with SWD connector
- Selection-mode switch to use the kit as a standalone ST-LINK/V2-1
- Flexible board power supply
- USB VBUS or external source (3.3 V, 5 V, 7 - 12 V)
- Power management access point
- User LED (LD2)
- Two push buttons: USER and RESET
- USB re-enumeration capability: three different interfaces supported on USB
- Virtual Com port
- Mass storage (USB Disk drive) for drag'n'drop programming
- Debug port
These headers give access to all STM32 pins.
Only the labels written in blue/white or green/white (i.e. PA_4, PB_5, A0, D14, LED1...) must be used in your code. The other labels are given as information (alternate-functions, power pins, ...).
You can find more details on the available pins and labels in the following files (link to the latest mbed-dev library version):
ST X-NUCLEO boards¶
Other Non-ST boards¶
This video shows how to get started with ARM mbed Integrated Development Environment using STM32 Nucleo platform:
Nucleo ST-LINK/V2 driver installation and firmware upgrade
For more information, please refer to:
The following section describes known limitations of the platform. Note that general issues are tracked into the mbed repository available on GitHub.
Note: Nucleo-F030R8 platform doesn't support RTOS due to its flash size. Please do not import mbed-rtos library into your project.
Please log in to start a discussion or ask a question.
Start new topic
1 day, 12 hours ago