Firmware update required
Please make sure you have updated your LPCXpresso to the latest firmware to enable the mbed flash disk interface
The LPC1549 LPCXpresso™ board with NXP's LPC1549 Cortex-M3 microcontroller is designed to make it as easy as possible to get started with your project. LPCXpresso is a low-cost development platform available from NXP supporting NXP's ARM-based microcontrollers. LPCXpresso is an end-to-end solution enabling embedded engineers to develop their applications from initial evaluation to final production.
- NXP LPC1549 MCU
- ARM® Cortex™-M3 Core
- 72MHz, 36KB RAM, 256KB FLASH
- USB Device, 2xSPI, I2C , UART, 6xADC, GPIO
- Arduino form-factor
- Leveraging the standard
- Compatible with a wide range of commercially available shields
- Built-in USB drag 'n' drop FLASH programmer
- mbed.org Developer Website
- Online Compiler
- High level C/C++ SDK
- Active devleoper community
Please note that mbed SDK of this platform support SWM (switch matrix) function, so you can assign any pins to any functions except AnalogIn, AnalogOut and I2C.
Supported shields on this platform
|Shield name||Shield type||Product page||Support status|
|mbed Application Shield||Display, Sensors||Click to view||Supported|
|Freetronics 16x2 LCD||Display||Click to view||Supported|
|Seeed SDCard V4b||Storage||Click to view||Supported (1)|
|W5200 Ethernet||Connectivity||Click to view||Supported (1)|
|Seeed Wifi||Connectivity||Click to view||Supported|
|Seeed Bluetooth||Connectivity||Click to view||Supported|
|Seeed NFC V2||Connectivity||Click to view||Supported (1)|
|Seeed XBee V2||Connectivity||Click to view||Supported|
|Seeed GPRS V2||Connectivity||Click to view||Supported|
|Ciseco SRF||Connectivity||Click to view||Supported|
|CSR GPS||Sensors||Click to view||Supported|
|Sparkfun GPS||Sensors||Click to view||Supported|
|Freescale Multi-Sensor||Sensors||Click to view||Supported (2)|
|Seeed EL||Drivers||Click to view||Supported|
|Seeed Relay V2||Actuators||Click to view||Supported|
|Seeed Energy||Power supply||Click to view||Supported|
|Seeed Charger V2||Power supply||Click to view||Supported|
|Seeed Grove V2||Hook-up||Click to view||Supported|
Shields support notes
- (1) - This shield requires SPI pins remapping because it uses a non-standard 6 pin SPI connector. Please refer to the shield page on mbed for more information.
- (2) - This shield uses I2C on A4/A5 pins and requires bridging of A4<->D14 and A5<->D15.
Please log in to start a discussion or ask a question.