File content as of revision 3:a643b6a454aa:

// MBED driver for AD9850 digital synthesizer using hacked SPI interface
// Original code by Liam Goudge Sept 2013
// Modified for KL25Z by Mike Richards Oct 2013

#include "mbed.h"


SPI device (PTD2, PTD3, PTD1); // Set the KL25Z SPI pins
DigitalOut CS(PTD0); // Use pin PTD0 as a fake Chip select
DigitalOut ADReset(PTA13); // Use Pin PTA13 as the reset line for AD9850


Serial pc(USBTX, USBRX); // tx, rx for debug terminal

int reverseBits (int source)
{
// Unfortunately need to invert bit order of the desired frequency setting since MBED only allows for MSB first from SPI. We need LSB first for AD9850
    int mask=0;;
    int i=0;
    int target=0;
    int bitTarget=0x80000000; // Hard-wired for 32-bit inversion

    for (i=0;i<32;i++) { // ditto
        mask=1<<i;   
        bitTarget=1<<(31-i); // ditto

        if (source & mask)
            target=target | bitTarget;
    } 
    return target;
}    
     
void writeSPI(int frq, int phase)
{           
// Send the 40-bit packet. NB: KL25Z only supports 8-bit SPI so send five 8-bit packets
    
    device.format(8,0); // 8-bits per packet, mode 0 (CPOL=0 CPHA=0)
    device.frequency(1000000); //SPI clock set to 1MHz

    wait_ms(1);

    // First do chip select. Need to use a GPIO to fake the chip select since MBED doesn't allow to set positive logic CS signal
    CS=1; // assert chip select (a.k.a FQ_UD frequency update input to AD9850)
    wait_ms(1);
    CS=0;
        
    device.write(frq>>24); // Write upper 8-bits
    device.write(frq>>16);
    device.write(frq>>8);
    device.write(frq); // Now the last 8 bits
    device.write(phase); // This is phase and factory settings byte

    // Now pulse FQ_UD again to load the word into the DDS
    CS=0;
    wait_ms(1);
    CS=1;
    wait_ms(1);
    CS=0;
}
    

int main()
{
    // This routine produces a continuous frequency sweep
    int targetFrq=0x147AE148; // Frequency word = ([Desired freq in MHz] * 34.3597384)
    int increment=0xD6B; //100Hz step
    
    // Reset the AD9850. Active high logic. Minimum reset period 5 clock cycles (5/125MHz)
    ADReset=0;
    wait_ms(5);
    ADReset=1;
    wait_ms(5);
    ADReset=0;
    
    while(1)
    {
    
    
   
   while (targetFrq<0x148bFFFF) // up to 10.001MHz
    {
        writeSPI(reverseBits(targetFrq),0); // Don't use phase so set to zero.
        targetFrq=targetFrq+increment;
        //wait_ms(200);
        }
        
    while (targetFrq>0x147AE148) // down to 10MHz
    {
        writeSPI(reverseBits(targetFrq),0);
        targetFrq=targetFrq-increment;
        //wait_ms(200);
        }  
    
    }      
        
        
}