Vijayaraghavan Narayanan

Important changes to forums and questions

All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.

9 years, 3 months ago.

stuck on btle_init>>

Hi,

I imported this program and on running , my terminal is stuck on ->

Initializing btle_init>>

... nothing after that ...

Any idea ?

Thanks. -Vijay

Question relating to:

Last updated: 19 Dec 2014
Heart Rate monitor example for the Nucleo board and the Bluetooth Low Energy Nucleo board.

I know this post is 7 months old, but it seems I am stuck with the same problem. Connecting Pin11 and Pin31 on CN10 (double checked its not CN7) as shown didn't change anything. Help please.

I am using NucleoF411RE board with BlueNRG shield X-NUCLEO-IDB04A1.

posted by Aravind Parvathala 10 Aug 2015

Hi Aravind,

if have a NUCLEO-F411RE with Pin11 and Pin31 shorted, you can't use the LED on the Nucleo and the BlueNRG shield at the same time. The reason is that in such a configuration, the LED pin and the SPI clock are shorted and cannot be controlled successfully at the same time.

Hope that helps, Antonio.

posted by Antonio Vilei 01 Oct 2015

1 Answer

slim.jallouli@...
9 years, 3 months ago.

Hi

Use a jump wire to connect pin 11 to pin 31 of the CN10 or on the BlueNRG shields (Remove R10 and assemble R11)

/media/uploads/sjallouli/nucleo_jump_wire.jpg Thank you.

Accepted Answer

hello,

I am getting randomly this error -

btle_init>> AddService(): Type:0

added servHandle handle =0

Char Properties 0x10

Setting up Gatt GATT_INTIMATE_APPL_WHEN_READ_N_WAIT Mask

added bleCharacteristic handle =17757

updating bleCharacteristic charHandle =17757, corresponding serviceHanle= 0

Error while updating characteristic.

Please clarify

posted by Vijayaraghavan Narayanan 22 Dec 2014

Hi Vijay,

We still don't have a clear answer on that.

Sorry for that.

Slim.

posted by slim.jallouli@... 22 Dec 2014

You get Error 17757 if you mix up CN7 and CN10 by connecting the jump wire between pin 11 and pin 31. Be care that the ST-Link module on the attached picture looks to the right.

posted by Alexander Eberhardt 03 Jul 2015